HP StoreEver ESL G3 Tape Libraries - Manual (Page 25)

2 Modifying the library configuration
Before you can manage your library from a remote Library Management Console (LMC) client,
you must initially configure the library from the Operator Control Panel (OCP) on the library itself
by either running the Setup Wizard command or using individual configuration commands from
the Setup menu.
After the initial setup, you can use either the OCP or the LMC to modify your library configuration.
The Setup menu includes most of the configuration commands.
NOTE: Only one administrator can be logged on and performing library configuration at any
one time. If another administrator attempts to log on, a message appears, warning that only one
administrator at a time is permitted on the library. If a service user logs on while an administrator
or regular users are logged on already, the library automatically logs off those users.
Setup Wizard prerequisites
Before you run the Setup Wizard:
•
Note the name and IP address of your network Domain Name Server (DNS) or the IP address,
subnet mask, and default gateway for your network segment.
•
Verify that your network is attached to the library network connection.
Accessing the Setup Wizard
Before using the Setup Wizard, see “Setup Wizard prerequisites” (page 25) .
To access the setup wizard from the OCP or the LMC:
1.
Log on as administrator. The home screen appears.
2. Verify in the System Information section, in the Name field that the physical library is selected.
If necessary, select it by one of the following methods:
•
In the Managed Views section of the screen, click on the name of the physical library.
•
From the menu bar, select View, then the name of the library.
3. Click Setup
→Setup Wizard to display the About Setup Wizard screen.
4. Use the buttons at the bottom of the wizard dialog box to navigate to the procedures you want
to perform. The procedures available from the Setup Wizard are:
•
“Entering License Keys” (page 25)
•
Setting up partitions (see “Creating partitions” (page 29) , “Modifying partitions” (page
35) , and “Deleting partitions” (page 38) )
•
“Enabling or disabling IPv6 and IPv4 network configuration” (page 42)
•
“Specifying the date and time using the Setup Wizard” (page 46)
Entering License Keys
Enable license keys in the following situations:
•
During initial installation and configuration of the library.
•
During a capacity on demand (COD) or feature upgrade.
•
When enabling ESKM. See “Enabling the ESKM License Key” (page 221) for specific instructions.
•
When enabling KMIP. See “Using the Key Management Interoperability Protocol (KMIP)
feature” (page 224) for specific instructions.
If you cannot locate the license instructions shipped with the library, you can obtain them by
contacting HP Support.
Setup Wizard prerequisites 25