HP StoreEver ESL G3 Tape Libraries - Manual (Page 145)

7. On IVT Pre-Test Questionnaire, complete the pre-test questionnaire by clicking inside the box
next to the questions.
You cannot continue with the installation verification test until you have completed and verified
the requests on this questionnaire.
NOTE: Ensure that you physically verify each of the questions on the questionnaire. Each
of the items listed can cause the installation verification test to have unexpected behavior and
unreliable results. The tests must be re-run if they fail.
8. After you complete the questionnaire, click Next.
An Attention dialog box instructs you to insert a scratch cartridge in the I/E station.
9. Insert a scratch cartridge into the I/E station, then click Next.
NOTE: Ensure that the scratch tapes are formatted and contain no data that cannot be
overwritten. Scratch tapes must have barcode labels with valid volume serial numbers on
them. Also, you might find it useful to write down the serial numbers so that you can identify
your scratch tapes.
This procedure will not damage any cartridges that are already installed in the library.
If the scratch cartridge becomes lodged in a drive or magazine, it must be manually removed
from the library. If not removed, the cartridge will become part of the partition the next time
the accessor assembly is enabled.
The I/E station will be locked until the inventory is complete.
Working with verification tests 145