HP StoreEver ESL G3 Tape Libraries - Manual (Page 260)

G Product Safety Statements
This product is designed for data storage and retrieval using magnetic tape. Any other application
is not considered the intended use. HP will not be held liable for damage arising from unauthorized
use of the product. The user assumes all risk in this aspect.
This unit is engineered and manufactured to meet all safety and regulatory requirements. Be aware
that improper use may result in bodily injury, damage to the equipment, or interference with other
equipment.
WARNING! Read all operating instructions in this manual before powering on or using this
equipment.
CAUTION: Read all operating instructions in this manual before operating this product.
NOTE: When drive sled positions are empty, drive cover plates must be installed and in place
at all times to prevent access into the empty drive sled positions, and promote proper air flow and
cooling.
Mechanical Locks
The access and service doors can be locked with a key. The key should be kept by an authorized
person at your company. Access to the interior of the library is both a data-integrity and a safety
issue.
Power Button on the Library Indicator Panel
Switching off the Power button on the indicator panel, located on the front of the library, removes
power from the electronics, which causes the picker to stop immediately. This button also removes
power from the drives.
WARNING! This power button functions as a power interrupt only. To completely remove all
power before servicing or in an emergency, turn off the circuit breaker on the power distribution
unit, and then disconnect the power cord from the electrical source.
260 Product Safety Statements