HP StoreEver ESL G3 Tape Libraries - Manual (Page 141)

Verification test descriptions
Installation verification test
The installation verification test enables you to verify that the library installation and configuration
is complete and functioning correctly. The installation verification test runs the following individual
tests:
•
Library alignment test
•
Picker assembly test
•
I/E station assembly test
•
Get/Put test
•
Scanner fiducial test
A smaller library configuration requires about 1 hour. Larger configurations require as long as 6
hours to run the installation verification test. The time to complete individual tests on an 8-frame
configuration is approximately:
•
Library alignment test: 30 minutes
•
Picker assembly test: 1 minute
•
I/E station assembly test: 5 minutes for each 24–slot I/E station
•
Get/Put test: 120 minutes
•
Scanner fiducial test: 75 minutes
Partial system tests
The partial system tests perform the selected sub-tests to test an area or range of the library
configuration. The selectable tests include:
•
Frame test: This test includes the same individual tests as the installation verification test, but
enables you to specify a range of modules rather than testing all modules.
•
Configuration test: This test includes the picker assembly and scanner fiducial tests.
Both tests enable you to select a range of modules and racks to test. For example, if you have a
4-module library, you can select to test only modules 3 and 4. The frame test performs the same
operations as the installation verification test, except there are frame and rack range parameters
available.
Field replaceable unit operational tests
The field replaceable unit (FRU) operational tests enable you to verify the replacement of a FRU.
When the FRU test is selected, you can select any of the following individual tests:
•
Accessor assembly
•
Picker assembly
•
Drive sled assembly
•
I/E assembly
•
Scan barcode
•
Tower assembly
When one of the sub-tests is selected, you might be prompted to enter additional information.
Custom library alignment tests
The custom tests enable you to run a sub-test that is normally part of the larger tests that call multiple
sub-tests (including installation and partial tests).
Working with verification tests 141