HP Hitachi Dynamic Link Manager Software - Manual (Page 68)

2. HDLM Functions
46
#1
The severity levels are as follows:
3: Error, 4: Warning, 6: Informational
#2
If you use Ctrl + C to cancel the
DLMgetras
utility for collecting HDLM error
information, audit log data indicating that the
DLMgetras
utility has terminated
will not be output.
2.12.2 Requirements for Outputting Audit Log Data
HDLM can output audit log data when all of the following conditions are satisfied:
• The
syslog
daemon is active.
• The output of audit log data has been enabled by using the HDLM command's
set
operation.
However, audit log data might still be output regardless of the above conditions if, for
Processing of the
dlmsetconf [-d]
[-r]
command was
successful.
6 KAPL15022-I
Processing of the
dlmsetconf [-d]
[-r]
command failed.
3 KAPL15023-E
Processing of the
dlmsetconf [-d] -u
command was
successful.
6 KAPL15024-I
Processing of the
dlmsetconf [-d] -u
command failed.
3 KAPL15025-E
Processing of the
dlmvxexclude [-d]
command was
successful.
6 KAPL15026-I
Processing of the
dlmvxexclude [-d]
command failed.
3 KAPL15027-E
Category Explanation Audit event
Severity #
1
Message ID