HP Hitachi Dynamic Link Manager Software User Manual
Page 255

3. Creating an HDLM Environment
233
group to be registered in Sun Cluster into only one of the nodes.
5.
If the VxVM disk group is not registered in Sun Cluster, execute the
scsetup
utility from the node into which you imported the VxVM disk group to be
registered in Sun Cluster, and then register the VxVM disk group into a Sun
Cluster disk device group.
For details, refer to the explanation of system administration in the Sun Cluster
documentation.
The following shows the procedure:
• Start the
scsetup
utility.
# /usr/cluster/bin/scsetup
The
Main Menu
appears.
• Enter 5 (Device group and volumes) to perform operations on the VxVM
disk device group.
The
Device Group Menu
appears.
• Enter 1 (Register a VxVM disk group as a device group) to register the
VxVM disk device group.
Following the prompts, specify the VxVM disk group name to be registered
as a Sun Cluster disk device group, the priority level of the master node, and
whether or not to perform switchback.
Note
After you enter this information, the following message may be output to
syslog:
KAPL05023-E Could not process the
IOCTL(00004D03).(00000000:00000000)
Even if this message is output to syslog, no problems exist operationally,
provided that the
Status
of the device group newly registered in the
following step is
Online
.
• Confirm that the disk device group is registered, and that its
Status
is
Online
.
If the disk device group was registered appropriately, use of the following
command will display information about the new disk device group:
# /usr/cluster/bin/scstat -D