HP Hitachi Dynamic Link Manager Software - Manual (Page 343)

4. HDLM Operation
321
Using a text editor, edit the definitions in the HDLM driver unconfiguration
definition file (
/opt/DynamicLinkManager/config/dlmfdrv.unconf
) for
the LU to be managed by HDLM.
Based on the path information of the LU to be managed by HDLM checked in step
1 (shaded portion), find the correct LU in the HDLM driver unconfiguration
definition file, and add a hash mark (#) in front of the
LDEV
property line
corresponding to the LU. Adding the hash mark specifies that the LU indicated
by that LDEV attribute is to be managed by HDLM.
Figure 4-6: The /opt/DynamicLinkManager/config/dlmfdrv.unconf file (before
editing) and Figure 4-7: Example of editing the /opt/DynamicLinkManager/
config/dlmfdrv.unconf file show examples of editing the HDLM driver
unconfiguration definition file (
/opt/DynamicLinkManager/config/
dlmfdrv.unconf
).
Figure 4-6: The /opt/DynamicLinkManager/config/dlmfdrv.unconf file (before
editing)
Figure 4-7: Example of editing the /opt/DynamicLinkManager/config/
dlmfdrv.unconf file
The shaded portion indicate the text to be edited.
Note
Do not edit anything other than adding the hash mark (
#
) to the beginning of
the
LDEV
property line.
3. Apply the contents that were edited in step 2 to the HDLM driver configuration