HP Hitachi Dynamic Link Manager Software - Manual (Page 492)

7. Utility Reference
470
Legend:
Optional: If you omit the key name and value, the default is used.
However, for an upgrade installation or re-installation, the previous license
information will be inherited for the
licensekeyfile
key.
#1
Only one key name and value can be specified on each line.
#2
Specifying an invalid value causes an error.
#3
When you perform a new installation of HDLM or when you upgrade HDLM
after the license has expired, make sure that you have a valid license key file.
[ENVIRONMENT_SETTINGS]
section
This section defines operation information for the HDLM command's
set
operation.
This section can be omitted. If the section name is not specified or if no keys are
specified in the section, setup by the HDLM command's
set
operation is not
performed.
For details on the HDLM command's
set
operation, see 6.6 set (Sets Up the
Operating Environment).
Table 7-5: Keys that Can Be Defined in the [ENVIRONMENT_SETTINGS] Section
describes the keys that can be defined in the
[ENVIRONMENT_SETTINGS]
section.
restart
Specify whether to restart the
host after installation by
specifying either of the following
values:
y
: Restart the system.
n
: Do not restart the system
(default).
If you use Sun Cluster, specify
n
.
Optional Optional 1
Key name #1 Explanation #2 Required or optional? Maximum
length
(character
s)
For new
installati
on
For
upgrade
installation
or
re-installati
on