HP Hitachi Dynamic Link Manager Software - Manual (Page 274)

3. Creating an HDLM Environment
252
When using Sun Cluster:
host1# umount /global/diskset1/d1
host1# metaclear -s diskset1 d1
2. Delete the disk from the shared diskset.
The following shows an example of executing the command.
When not using Sun Cluster:
host1# metaset -s diskset1 -d -f c5t1d2 c5t1d3
When using Sun Cluster:
host1# metaset -s diskset1 -d -f /dev/did/dsk/d10 /dev/did/
dsk/d11
3. Delete the shared diskset.
The following shows an example of executing the command.
host1# metaset -s diskset1 -d -f -h host1 host2
(6) Remove SVM Settings
If you are using SVM, before you uninstall HDLM, perform the following to delete the
registration of HDLM devices from SVM.
Note
Deleting a volume deletes data in the volume. Make sure that you backup the data.
When using a local volume
1. Execute the following command to unmount the file system:
The following shows an example of executing the command:
host1# umount /mnt/filesystem1
2. Delete the SVM local volume that is using the HDLM device.
The following shows an example of executing the command to delete SVM local
volume
d0
.
host1# metaclear d0