HP Hitachi Dynamic Link Manager Software User Manual
Page 135

3. Creating an HDLM Environment
113
After confirming that the KAPL09211-I message has been output, execute the
following command to delete the installation-information settings file:
# rm -r /
any-directory
/
installation-information-settings-file
If the
driver_config
key is set to
n
(so that the
dlmsetconf
utility is not
executed) in the installation-information settings file, go to step 9.
If the
restart
key is set to
n
(so that the computer is not restarted) in the
installation-information settings file, go to step 11.
If the
restart
key is set to
y
(to restart the computer) in the
installation-information settings file, go to step 14.
7.
Continue by following the instructions displayed on the screen.
If the license key file named
/var/tmp/hdlm_license
is not saved, a message,
showing whether a user-specified license key file has been saved, is output. Enter
1
if a user-specified license key file has been saved. Enter
2
if a license key is
specified directly.
• Note that if any value other than
1
or
2
is entered three times, the installation
is stopped.
If
1
is entered, specify a user-specified license key file with the absolute path.
• Note that if the wrong absolute path is entered three times, the installation is
stopped.
If
2
is entered, a message that prompts you to enter a license key is displayed.
Enter the license key.
• When a correct license key is entered, the installation program displays a
message that indicates the license was installed.
• Take care that if you enter an incorrect license key three times, installation
stops.
If you interrupt an installation, check whether the
/var/opt/
DynamicLinkManager
directory exists.
If the
/var/opt/DynamicLinkManager
directory exists, execute the following
command to delete it:
# rm -rf /var/opt/DynamicLinkManager
8.
Execute the following command to check whether HDLM 6.5.1 has been installed
successfully:
Make sure that
VERSION
appears as
06.5.1.0000
.