beautypg.com

HP Hitachi Dynamic Link Manager Software User Manual

Page 360

background image

4. HDLM Operation

338

If the key is displayed, place the LU under HDLM management by following the

steps from step 5 of (2) Changing a Non-HDLM-Managed Device to an

HDLM-Managed Device (When the Node Must Be Restarted) in 4.5.6 Specifying

Whether a Logical Unit Is To Be Managed by HDLM (When Using Sun Cluster).

Even when you release the setup for Quorum devices and disk device groups,

since the key used for disk reservation will remain registered, you will need to

restart the node in non-cluster mode and unregister the key.
If the key is not displayed, perform the steps beginning with step 5.

5.

Edit the HDLM driver unconfiguration definition file (

/opt/

DynamicLinkManager/config/dlmfdrv.unconf

).

Using a text editor, edit the definitions in the HDLM driver unconfiguration

definition file (

/opt/DynamicLinkManager/config/dlmfdrv.unconf

) for

the LU to be managed by HDLM. Based on the path information of the LU to be

managed by HDLM checked in step 2 (shaded portion), find the correct LU in the

HDLM driver unconfiguration definition file (

/opt/DynamicLinkManager/

config/dlmfdrv.unconf

), and add a hash mark (#) in front of the

LDEV

property line corresponding to the LU. Adding the hash mark specifies that the

LU indicated by that LDEV attribute is to be managed by HDLM.
Figure 4-17: The /opt/DynamicLinkManager/config/dlmfdrv.unconf file (before

editing) and Figure 4-18: The /opt/DynamicLinkManager/config/

dlmfdrv.unconf file (after editing) show examples of editing the HDLM driver

unconfiguration definition file (

/opt/DynamicLinkManager/config/

dlmfdrv.unconf

).

Figure 4-17: The /opt/DynamicLinkManager/config/dlmfdrv.unconf file

(before editing)