HP Hitachi Dynamic Link Manager Software - Manual (Page 423)

6. Command Reference
401
Example 6
The following example shows how to display information about the audit log
settings:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log : off
Audit Log Category : -
Audit Log Facility : -
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time =
yyyy
/
mm
/
dd hh
:
mm
:
ss
#
(2) To display path information
When displaying path information, if you specify either the
-item
or
-c
parameter
and also specify the
-path
parameter, you can select the items to display and display
a summary of path information. This section describes each parameter and the
displayed path information.
To display path information
-path
When you specify the
-path
parameter and do not specify either the
-c
or
-item
parameter, the command displays information about the paths managed by
HDLM without abbreviating or selecting items.
In the sub-parameters (following
-path
), you can filter the paths to be listed
using
-hdev
and sort the list using
-srt
. When you omit both parameters, the
command displays information for all the paths in order of increasing
AutoPATH_IDs.
For details on what is displayed in each item, see Table 6-12: Displayed Path
Information.
AutoPATH_IDs displayed by the
-path
parameter depend on the sequence in
which HDLM detects the paths after a host is started up. Because of this, make
sure that you use the path name
PathName
to identify a path.
The following shows the subsequent sub-parameters (following
-path
):
-hdev
host-device-name
Displays information only for the paths accessing the specified host device.
Specify the name of the logical device file (minus the slice number, in
c
U
t
X
d
Y format) for the HDLM device to indicate the desired host device.
The host-device-name string is case-sensitive.
-stname