HP Hitachi Dynamic Link Manager Software User Manual
Page 226
3. Creating an HDLM Environment
204
value is 0.
If you do not want to change the monitoring interval, leave New Span(sec) blank,
type
!
, and then press the Enter key to return to the Hitachi Network Objectplaza
Trace Library setup menu.
Note that when you specify a monitoring interval of 0, even if you specify the
maximum number of messages in 7: Max messages per span, the amount of
integrated trace information to be output will not be adjusted.
3.
Press the Enter key.
The new setting is applied and the Hitachi Network Objectplaza Trace Library
setup menu appears again.
4.
In the Hitachi Network Objectplaza Trace Library setup menu, type
7
, and then
press the Enter key.
A screen to set the maximum number of messages output to the integrated trace
file based on the monitoring interval specified in 6: Lookout span appears. The
current value is displayed in Current Max(sec).
5.
Adjust the maximum number of messages output to the integrated trace files in
New Max(sec).
The default is 0. You can specify a value from 0 to 500 (messages). If you want
to increase the number of messages that are output to the integrated trace file as
much as possible, we recommend that you set this value to 0.
When you specify a monitoring interval of 0 in 6: Lookout span, the value set in
New Max(sec) will be disregarded.
Also, when you specify a value of 0 for New Max(sec), even if you specify the
monitoring interval in 6: Lookout span, the maximum number of messages
output will not be adjusted.
If you do not want to change the maximum number of messages output, leave
New Max(sec) blank, enter
!
, and then press the Enter key to return to the
Hitachi Network Objectplaza Trace Library setup menu.
6.
Press the Enter key.