HP Hitachi Dynamic Link Manager Software - Manual (Page 131)

3. Creating an HDLM Environment
109
- The node is in the Offline status.
- Both the current
Quorum votes present
and
Quorum votes
possible
are 0.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scstat -q
8. If the cluster is a two-node configuration, enter the install mode.
If the cluster consists of three or more nodes, this step is not necessary so go
to step 9. The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -c -q installmode
9. Release the settings of the last Quorum device.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -r -q
globaldev=
Quorum-device's-device-ID
10. At a node that is not in the maintenance mode, switch to become the
superuser.
If the cluster consists of two nodes, go to step 12. If the cluster consists of
three or more nodes, go to step 11.
11. If the cluster consists of three or more nodes, reset the cluster Quorum votes.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -c -q node=host1,reset
12. Change the mode of the node, which you changed into the maintenance
mode, back to the previous mode.
At the
ok
prompt, execute
boot
.
13. If the cluster consists of two nodes, make sure that the node (which was
changed into the maintenance mode) that you want to change back to the
previous mode is active, and then reset the cluster Quorum votes. If the
cluster consists of three or more nodes, this step is not necessary.
The following shows an example of executing the command:
host2# /usr/cluster/bin/scconf -c -q node=host1,reset