HP Hitachi Dynamic Link Manager Software User Manual
Page 395

6. Command Reference
373
CHA port whose CHA-port-ID is
00001.
# /opt/DynamicLinkManager/bin/dlnkmgr offline -chaid
00001
KAPL01104-I All the paths which pass the specified CHA
port will be changed to the Online status. Is this OK?
[y/n]:y
KAPL01061-I 15 path(s) were successfully placed Online;
0 path(s) were not. Operation name = online
#
-pathid
AutoPATH_ID
Use this parameter to place a single path online.
Specify the current AutoPATH_ID of the target path, which is displayed by using
the
view
operation. For details on the
view
operation, see 6.7 view (Displays
Information). Leading zeros can be omitted (
000001
and
1
indicate the same
AutoPATH_ID). Therefore, when the target AutoPATH_ID is
000000
, enter
000000
or
0
for the parameter value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you want
to add a new LU without restarting the host, AutoPATH_IDs are re-assigned to
each path of the LU when you execute the
dlmcfgmgr
utility. Always make sure
that you execute the
view
operation to find the current AutoPATH_ID of the
target path, before executing the
online
operation.
-device
SCSI-device-name
Use this parameter to place online all paths connected to the specified SCSI
device.
For SCSI-device-name, specify the value of
Device
displayed by executing the
view
operation as follows:
# /opt/DynamicLinkManager/bin/dlnkmgr view -lu
For details on how to execute the
view
operation and display the SCSI device
name, see (3) To display LU information in 6.7.2 Parameters. Only one
case-sensitive parameter value can be specified.
Example
The following shows an example of how to place online all paths whose
SCSI device name is
sd52
while confirming command operation.
# /opt/DynamicLinkManager/bin/dlnkmgr online -path
-device sd52
KAPL01050-I The currently selected paths will be changed
to the Online status. Is this OK? [y/n]:y
KAPL01061-I 1 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online