HP Hitachi Dynamic Link Manager Software - Manual (Page 436)

6. Command Reference
414
(3) To display LU information
When displaying LU information, if the
-item
parameter,
-c
parameter, or the
-c
-item
parameter is specified at the same time as the
-lu
parameter, you can add and
display items and display a summary of LU information. This section describes each
parameter and the LU information and displayed items.
To display LU information
-lu
When neither the
-c
nor
-item
parameter is specified with the
-lu
parameter,
the information about the LU recognized by HDLM is displayed. The sorting key
is iLU and its configuration information is displayed for each LU.
By using the sub-parameter,
-hdev
or
-pathid
, you can filter the LU
information to be displayed. If you do not specify the
-hdev
or
-pathid
parameter, the information about all LUs recognized by HDLM is displayed.
For details on the content of each displayed item, see Table 6-17: Displayed LU
Information.
The following shows the sub-parameters:
-hdev
host-device-name
Filters the information only for the LUs corresponding to the specified host
device.
Specify the name of the logical device file (minus the slice number, in
c
U
t
X
d
Y format) for the HDLM device to indicate the desired host device.
The host-device-name string is case-sensitive.
-pathid
AutoPATH_ID
Use this parameter to display only the information about the LU that is
connected to the path with that specified AutoPATH_ID.
-t
Omits the title for each information item.
Example
# /opt/DynamicLinkManager/bin/dlnkmgr view -lu
Product : 9500V
SerialNumber : 0051
LUs : 3
iLU HDevName Device PathID Status
0001 c6t2d0 sd61 000003 Online
sd64 000009 Online