HP Hitachi Dynamic Link Manager Software User Manual
Page 184

3. Creating an HDLM Environment
162
/dev/dsk/c0t0d0s6 /dev/rdsk/c0t0d0s6 /usr ufs 1 no -
/dev/did/dsk/d24s3 /dev/did/rdsk/d24s3 /global/
.devices/node@1 ufs 2 no global
#
Execute the
scdidadm
-l
command to find out the device ID to specify as
the mount device of the Sun Cluster global device file system. In the
following example,
d30
is the pre-migration boot disk, and
d24
is the
post-migration boot disk.
# scdidadm -l
...
24 node1:/dev/rdsk/c0t0d0 /dev/did/rdsk/
d24
...
30 node1:/dev/rdsk/c8t50060E80004361D1d1 /dev/did/
rdsk/d30
15. Edit the post-migration boot disk's
/etc/vfstab
file, changing the swap device
definition from the pre-migration boot disk to the post-migration boot disk.
An example is shown below.
Before editing
/dev/dsk/c8t50060E80004361D1d1s1 - - swap -
no -
After editing
/dev/dsk/c0t0d0s1 - - swap - no -
16. Edit the post-migration boot disk's
/etc/dumpadm.conf
file, changing the
dump device definition in the
DUMPADM_DEVICE
parameter from the
pre-migration boot disk to the post-migration boot disk.
An example is shown below.
Before editing
DUMPADM_DEVICE=/dev/dsk/c8t50060E80004361D1d1s1
After editing
DUMPADM_DEVICE=/dev/dsk/c0t0d0s1
17. Boot the system from the post-migration environment.
• Skip to step 18 if SDS or SVM is being used and you are migrating a replica