HP Hitachi Dynamic Link Manager Software - Manual (Page 353)

4. HDLM Operation
331
The following shows an example of executing the command:
# /usr/cluster/lib/sc/scsi -c scrub -d /dev/rdsk/
c3t50060E80033A9902d2s2
8. Make sure that the key for the LU to be managed by HDLM has been
unregistered.
Perform step 4 again on any node, and check that the key is not displayed.
9. Edit the HDLM driver unconfiguration definition file (
/opt/
DynamicLinkManager/config/dlmfdrv.unconf
).
Using a text editor, edit the definitions in the HDLM driver unconfiguration
definition file (
/opt/DynamicLinkManager/config/dlmfdrv.unconf
) for
the LU to be managed by HDLM. Based on the path information of the LU to be
managed by HDLM checked in step 2 (shaded portion), find the correct LU in the
HDLM driver unconfiguration definition file (
/opt/DynamicLinkManager/
config/dlmfdrv.unconf
), and add a hash mark (#) in front of the
LDEV
property line corresponding to the LU. Adding the hash mark specifies that the
LU indicated by that LDEV attribute is to be managed by HDLM.
Figure 4-14: The /opt/DynamicLinkManager/config/dlmfdrv.unconf file (before
editing) and Figure 4-15: The /opt/DynamicLinkManager/config/
dlmfdrv.unconf file (after editing) show examples of editing the HDLM driver
unconfiguration definition file (
/opt/DynamicLinkManager/config/
dlmfdrv.unconf
).
Figure 4-14: The /opt/DynamicLinkManager/config/dlmfdrv.unconf file
(before editing)