A. sun cluster 3.2 commands – HP Hitachi Dynamic Link Manager Software User Manual
Page 636

A. Sun Cluster 3.2 Commands
614
A. Sun Cluster 3.2 Commands
Table A-1: Correspondence Between Sun Cluster 3.1 Commands and Sun Cluster 3.2
Commands shows the correspondence between Sun Cluster 3.1 commands and Sun
Cluster 3.2 commands. For details about the command options, see the documentation
for Sun Cluster 3.2.
#
#
Note that there are no differences between Sun Cluster 3.2 commands and Oracle
Solaris Cluster 3.3 commands.
Table A-1: Correspondence Between Sun Cluster 3.1 Commands and Sun
Cluster 3.2 Commands
Commands for Sun Cluster 3.1
Commands for Sun Cluster 3.2
scconf -a -q
globaldev=
device-ID-of-the-Quorum-device
clquorum add
device-ID-of-the-Quorum-device
scconf -c -q installmode
cluster set -p installmode=enabled
scconf -c -q node=
node-name
,maintstate
clquorum disable -t node
node-name
scconf -c -q node=
node-name
,reset
• Change the mode of the node from the
maintenance mode to the previous mode, and
then reset the quorum vote count.
#1
clquorum enable -t node
node-name
• Reset the quorum vote count
#2
clquorum reset
scconf -c -q reset
clquorum reset
scconf -pv | grep Quorum
clquorum show
scconf -r -q
globaldev=
device-ID-of-the-Quorum-device
clquorum remove
device-ID-of-the-Quorum-device
scdidadm -C
cldevice clear
scdidadm -L
cldevice list -v
scdidadm -l
cldevice list -n
node-name
-v
scdidadm -r
cldevice refresh
scdidadm -ui
scdidadm -ui
scgdevs
cldevice populate