HP Hitachi Dynamic Link Manager Software - Manual (Page 156)

3. Creating an HDLM Environment
134
hdlm_license
is not already saved, a message is output asking whether a
user-specified license key file has been saved. Enter
1
if a user-specified license
key file has been saved. Enter
2
to specify a license key directly.
• Note that if any value other than
1
or
2
is entered three times, the installation
is stopped.
If
1
is entered, specify a user-specified license key file with the absolute path.
• Note that if the wrong absolute path is entered three times, the installation is
stopped.
If
2
is entered, a message that prompts you to enter a license key is displayed.
Enter the license key.
• When a correct license key is entered, the installation program displays a
message that indicates the license was installed.
• Take care that if you enter an incorrect license key three times, installation
stops.
6. Execute the following command to check that the package is installed, by the
version number in the output results:
The following shows an example of executing the command:
# pkginfo -l DLManager
PKGINST: DLManager
NAME: Dynamic Link Manager
CATEGORY: system
ARCH: sparc
VERSION:
xx.x.x.xxxx
BASEDIR: /
VENDOR:
...
#
7. Restart the host.
When Sun Cluster is not being used:
Execute one of the following commands:
•
# reboot
•
boot
(at the
ok
prompt)
When Sun Cluster is being used:
Execute the following command at one of the nodes:
# /usr/cluster/bin/scshutdown -g0 -y