beautypg.com

HP Hitachi Dynamic Link Manager Software User Manual

Page 120

background image

3. Creating an HDLM Environment

98

To allocate the HDLM device for each LU, execute the following command:


zonecfg:zone1:device> set match=/dev/rdsk/
c5t50060E800436E211d0*

To allocate the HDLM device for each controller, execute the following

commands, and then restart the non-global zone:


zonecfg:zone1:device> set match=/dev/rdsk/c5t*
zonecfg:zone1:device> end
zonecfg:zone1> verify
zonecfg:zone1> commit
zonecfg:zone1> exit
#

For details on the commands, refer to the Solaris 10 documentation.

Table 3-18: Support for the Solaris zones shows the HDLM support for the

Solaris zones.
Table 3-18: Support for the Solaris zones

„

When performing a new installation or upgrade installation of HDLM using the

pkgadd

command, respond as follows when the message output by the

pkgadd

command prompts you to enter information:

When you want to continue the installation, respond to all prompts by

entering

y

.

When you want to interrupt or stop the installation, respond by entering

q

.

„

Before you perform the following operations in an environment whose run level

is less than 2, execute the procedure described in (1) Initializing HDLM When the

Host Is Started in Single-User Mode in 4.1.9 Operation in Single-User Mode:

Installing HDLM

Item

Global zone

Non-global zone

Remarks

Installing HDLM

Supported

Not supported

--

Path operations

Supported

Not supported

--

Displaying path statuses

Supported

Not supported

--

Accessing HDLM devices

Supported

Supported

The devices must be

allocated to the relevant

zone.

Uninstalling HDLM

Supported

Not supported

--