HP Hitachi Dynamic Link Manager Software - Manual (Page 363)

4. HDLM Operation
341
Execute the following command:
# /usr/cluster/bin/scgdevs
13. When using an HDLM-managed device, as a Quorum device, set the Quorum
device on any node in the cluster.
The following shows examples of executing the commands:
Check the device ID of the HDLM device:
# /opt/DynamicLinkManager/bin/dlnkmgr view -path
# /usr/cluster/bin/scdidadm -L
Set up the Quorum device:
# /usr/cluster/bin/scconf -a -q globaldev=d4
Execute the following command to clear the install mode of a cluster when it
consists of two nodes:
# /usr/cluster/bin/scconf -c -q reset
14. Execute the following command to view the HDevName and iLU columns:
# /opt/DynamicLinkManager/bin/dlnkmgr view -path
Check the correspondence between
HDevName
(the name of the logical device
file of the HDLM device) and
iLU
(the internal LU number) from the execution
results of the command, compare the correspondence with the correspondence
that took place before the HDLM installation, and then re-register HDLM devices
with the programs that will use them.
If you want to use volume management software to create a file system on an
HDLM-managed device, skip to step 16.
15. Perform registration for the disk device group.
If you are using VxVM, see 3.13.5 Linking VxVM and Sun Cluster.
If you are using SDS, see (2) To Use a Shared Diskset of 3.14.2 Registering
HDLM Devices.
If you are using SVM, see (2) To Use a Shared Diskset of 3.15.2 Registering
HDLM Devices.