HP Hitachi Dynamic Link Manager Software User Manual
Page 125

3. Creating an HDLM Environment
103
Figure 3-3: An example of how to edit the /etc/vfstab file
Comment the shaded portions out by placing a hash mark (
#
) at the
beginning of the line, or delete the line.
7.
Unregister the device from the volume management software.
If the device is registered in VxVM, SDS, or SVM, cancel the registration.
(2) Apply Solaris Patches
See 3.1.1 Hosts and OSs Supported by HDLM, and then apply any necessary patches
to the Solaris OS.
(3) Set Up the Hardware
For a Fibre Channel connection, check the topology (Fabric, AL, etc.) and perform
setup as appropriate.
To set up the hardware:
1.
Set up the storage system.
For details on how to set up the storage system, see the HDLM Release Notes that
come with HDLM and the maintenance documentation for the storage system.
HDLM cannot manage command devices used by Hitachi CCI.
Use the Hitachi CCI functionality to configure any command device used by
Hitachi CCI so that it is in a redundant configuration.
2.
Set up the switches.
For details on how to set up a switch, refer to the switch documentation. This
setup is not necessary if no switch is being used.
3.
Set up the HBA.
For details on how to set up an HBA, see the HDLM Release Notes, and the HBA
documentation.