Teledyne LeCroy UWBTracer User Manual - Manual (Page 96)

Chapter 6: Display Options UWBTracer/Trainer User Manual
78
LeCroy Corporation
Setting Colors
The program uses a default set of colors for each type of data in each group of data. The
colors and color combinations are appropriate for most graphic systems. You can alter
any color.
To specify a color for an information type, in the Color/Format/Hiding tab, select a row
(such as Data) in the Group and Color column and expand it (see Figure 6.2).
Select a data type (such as Data Length) in the Group, then select a color in the Color
section, using Standard or Custom colors. Use a bright color for each important field
To customize colors, use the Custom tab.
Note: You cannot change color of an Invalid Data (packet error) field. It is
permanently set to red.
Changing Field Formats
For each type of data in each group of data, the program has a default data format.
Examples of number data formats are Bin (binary), Dec (decimal), and Hex
(hexadecimal). Examples of date and time data formats are Hex uFrame, Dec uFrame,
Date & Time, Time, Bit Time, seconds, microseconds, and nanoseconds. An example of
a text data format is ASCII. You can alter some data formats.
To specify a data format for an information type, in the Color/Format/Hiding tab, select a
row (such as Data) in the Group and Color column and expand it.
Select a data type (such as Payload) in the Group:
Figure 6.4 Group and Color Pane: Display Units Selected
Select a format in the Format section. The following formats are available for Payload:
Figure 6.5 Formats for Payload