Teledyne LeCroy UWBTracer User Manual - Manual (Page 275)

UWBTracer/Trainer User Manual Chapter 15: Creating and Editing Generation Files
LeCroy Corporation
257
The Send Frame Elements have the properties:
•
Frame Type: Beacon, Data, Command, Control, Agg_Data, WUSB_MMC,
WUSB_Data_Out, WUSB_Hand, WUSB_DN, WUSB_Data_In,
•
Template Name: Select first from a list of defined templates.
•
Send Time Method: Select Delay to set the Delay time (in nanoseconds) to
wait before sending the frame. Select SFOffset to set the Offset (in
microseconds) of the frame to be sent, in SuperFrame. Select AbsTime to set
the Absolute time (in microseconds) at which the frame is to be sent. Note:
When using the AbsTime time mode parameter, make sure that the first frame
sent has a time value greater than or equal to 10 microseconds, to ensure
correct timing between the first few frames of the scenario.
•
Send Time Method Value (us): Enter an integer.
•
Fine Time Adjustment (ns): Enter an integer.
•
Burst: BURST_BEGIN specifies the start of a burst sequence.
BURST_CONTINUE specifies that the burst sequence does not end.
BURST_END specifies the end of a burst sequence. IGNORE means not to
use a burst sequence.
•
Overrides: Specifies a bitmap that instructs the UWBTrainer to set values for
the TFC/BG, FCS, Scr, and Length fields from the frame template, rather than
calculating them automatically.
• Overrides OVR_TFC: Check or uncheck.
• Overrides OVR_FCS: Check or uncheck.
• Overrides OVR_SCR: Check or uncheck.
• Overrides OVR_LEN: Check or uncheck.
•
TimeVar Index: Enter the index name of the Time variable in which to keep
the condition timestamp when it is triggered or leave UNDEFINED. Default is
UNDEFINED (timestamp is not saved).
•
Rate: Select from list.
•
Reserved0: Enter an integer. Default is 0.
•
Reserved1: Enter an integer. Default is 0.
•
BG_Isb: Enter an integer. Default is 0.
•
PreType: Select from list.
•
BM: Select from list.
•
Reserved2: Enter an integer. Default is 0.
•
Reserved3: Enter an integer. Default is 0.
•
RETRY: Select from list.
•
CtrlType: Select from list.
•
FrameType: Enter a type.
•
AckPolicy: Select from list.