Teledyne LeCroy UWBTracer User Manual - Manual (Page 2)

UWBTracer/Trainer User Manual
LeCroy Corporation
Document Disclaimer
The information in this document has been carefully checked and is believed to be
reliable. However, no responsibility can be assumed for inaccuracies that may not have
been detected.
LeCroy reserves the right to revise the information in this document without notice or
penalty.
Trademarks and Servicemarks
LeCroy, UWBTrainer, UWBTracer, UWBTracer MPI, CATC Trace, and BusEngine are
trademarks of LeCroy.
Microsoft and Windows are registered trademarks of Microsoft Inc.
Intel and Pentium are registered trademarks of Intel Corporation.
AMD Duron and AMD Athlon are trademarks of Advanced Micro Devices, Inc.
All other trademarks are property of their respective companies.
Copyright
Copyright © 2008, LeCroy Corporation. All Rights Reserved.
This document may be printed and reproduced without additional permission, but all
copies should contain this copyright notice.
FCC Conformance Statement Compliance with
47 CFR 15.519 (a)(1)
This device complied with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC Rule 47 CFR 15.519 (a)(1) states that “A UWB device operating under the
provisions of this section shall transmit only when it is sending information to an
associated receiver. The UWB intentional radiator shall cease transmission within
10 seconds unless it receives an acknowledgement from the associated receiver that its
transmission is being received. An acknowledgement of reception must continue to be
received by the UWB intentional radiator at least every 10 seconds or the UWB device
must cease transmitting. “
This equipment may only be operated indoors. Operation outdoors is in violation of
47 U.S.C. 301 and could subject the operator to serious legal penalties.
Note: This device must be installed in a location that is not accessible to the general
public. Install the device so that the antenna is more than 20 cm from unsuspecting
personnel. Failure to install this device as described will result in a failure to comply with
FCC rules for RF exposure and is discouraged. Only antennas approved with the device
may be used. This device may not be co-located with other transmitters without further
approval by the FCC.
Caution: Changes or modifications not expressly approved by the party responsible for
compliance could void the operator’s authority to operate the equipment.