Teledyne LeCroy UWBTracer User Manual - Manual (Page 59)

UWBTracer/Trainer User Manual Chapter 3: Software Overview
LeCroy Corporation
41
Recording Status
During recording, current recording status is displayed in the next segment of the Status
bar (Figure 3.21). When recording is begun, one of the following messages flashes
(depending on options selected in the Recording Options window):
• Trigger?
• Triggered!
• Uploading
After recording stops, the following occurs:
• Flashing message changes to Uploading data–x% done (x% indicates the per-
centage completion of the data uploading process).
• Traffic data is copied to disk (overwriting any previous version of this file) using the
default file name data_xxx.uwb, where xxx is derived from the unit’s serial number.
You can specify the file name in the Recording Options window.
When the data is saved, the Recorded Data file appears in the Main display window, and
the Recording Status window is cleared.
• If the recording resulted from a trigger event, the first frame following the trigger (or
the frame that caused the trigger) is initially positioned second from the top of the
display.
• If the recording did not result from a trigger event, the display begins with the first
frame in the traffic file.
Recording Activity
During recording, the next segment of the Status bar (Figure 3.21) displays recording
activity as a series of vertical bars.
The more vertical bars that are displayed, the greater the amount of activity being
recorded. If there are no vertical bars, there is no recorded activity.
During uploading, the percent of the completed upload is displayed.
Search Status
The rightmost segment of the Status bar (Figure 3.21) displays current search direction:
Fwd (forward) or Bwd (backward).