Teledyne LeCroy UWBTracer User Manual - Manual (Page 207)

UWBTracer/Trainer User Manual Chapter 12: Recording Options
LeCroy Corporation
189
12.4 Recording Options: USB Assoc.
An USB Assoc. tab appears if you selected the following system operating mode:
• [Rec. Chan #1: Right MPI] [Rec. Chan #2: Right RF] [Supports USB
Association Capturing]
Note: For capturing the USB Cable Association traffic (as defined in the
Certified Wireless USB specifications) so it can be used to decrypt
WiMedia UWB traffic, the USB Analyzer plug-in module (US007MA) has to
be installed. For information on how to set up the system,
see Section 13.2 “USB Cable Association for Certified WUSB” on page 224.
Because the USB Analyzer plug-in module is always active and ready for capture, the
only setting needed is to choose the speed. Set the speed of the traffic recorded by the
Analyzer in the USB Association Capture Settings recording options on the USB Assoc.
page (Figure 12.6).
Figure 12.6 USB Assoc. Dialog Box
By default, the USB Association Capture Settings are disabled. Check the
USB Assoc Capture Settings checkbox to enable capture.