Teledyne LeCroy UWBTracer User Manual - Manual (Page 185)

UWBTracer/Trainer User Manual Chapter 11: Setting Up for Recording
LeCroy Corporation
167
To use the Cable Adapter to connect with an IDE 40-pin connector:
Step 1 Turn of the power on the analyzer and the device-under-test
Step 2 Connect the middle connector on the IDE 40-pin Probe Adapter to the 40-pin
connector on the Cable Adapter.
Step 3 Connect one of the end connectors on the IDE 40-pin Probe Adapter to the PHY
subsystem.
Step 4 Connect the other end connector on the IDE 40-pin Probe Adapter to the MAC
subsystem.
Step 5 Connect the Adapter Cable (SCSI) to the MPI ADAPTER connector on the
UWBTracer plug-in.
Step 6 Connect the Adapter Cable (SCSI) to the TO ANALYZER connector on the
Cable Adapter unit.
Step 7 Turn on the power, then start capturing data.
To use the Cable Adapter to connect with a Hirose 68-pin connector:
Follow the same steps as for the IDE 40-pin connector, but use the Hirose 68-pin Probe
Cable and the 68-pin connector on the Cable Adapter.
To use the Board Adapter to connect with a IDE 40-pin connector:
Step 1 Turn off the power on the analyzer and the device under test.
Step 2 Connect one side of the IDE 40-pin Board Adapter to the connector on the MAC
subsystem.
Step 3 Connect the PHY subsystem to the other IDE 40-pin connector on the Board
Adapter.
Step 4 Connect the Adapter Cable (SCSI) to the MPI ADAPTER connector on the
UWBTracer plug-in.
Step 5 Connect the other side of the Adapter Cable (SCSI) to the connector on the
Board Adapter.
Step 6 Turn on the power, then start capturing data.
To use the Board Adapter to connect with a Hirose 68-pin
connector:
Follow the same steps as for the IDE 40-pin connector, but use the Hirose 68-pin Board
Adapter.
To use the Board Adapter to connect with a Hirose 60-pin
connector:
Follow the same steps as for the IDE 40-pin connector, but use the Hirose 60-pin Board
Adapter.