Teledyne LeCroy UWBTracer User Manual - Manual (Page 247)

UWBTracer/Trainer User Manual Chapter 14: Traffic Generation Overview
LeCroy Corporation
229
Chapter 14: Traffic Generation Overview
After the UWBTracer/Trainer™ and DUT have been cabled and powered on, you can test
the setup by generating some traffic. The following steps show how to configure the
Exerciser to generate and run a training sequence.
14.1 UWBTrainer Overview
UWBTrainer™ creates and runs traffic generation files using the UWB Exerciser. You
download the compiled script to the device and run the script from the UWBTrainer.
Using scripts, packets can be transmitted one after another or with certain timing or
event-based pauses between them. This allows the UWBTrainer to act as a pattern
generator with specific formatting and transmission rates.
The traffic generator can emulate hosts and endpoint devices. Traffic generation can be
used to transmit known errors, allowing you to observe how your device handles faulty
link conditions.
Script execution can be throttled using Wait commands inserted directly into the script.
Waits can be time based, require receipt of certain packet types, or can even require
User input from the GUI.