Teledyne LeCroy UWBTracer User Manual - Manual (Page 176)

Chapter 10: Connecting to Analyzers UWBTracer/Trainer User Manual
158
LeCroy Corporation
You can display information about the analyzer, update the BusEngine/Firmware
(see Section 16.4, “BusEngine, Firmware, and Plugin Init Updates” on page 280), update
the license (see Section 16.5, “License Information” on page 282), or go to Recording
Options (see Chapter 7) using Setup > All Connected Devices...
Figure 10.2 Analyzer Network’ and All ‘Connected Devices…’ menus
USB Connected Analyzers Configuration
Configuration for two or more USB connected analyzers is minimal. In the following
example, two analyzers are linked via USB to a host PC. You connect to one of the two
analyzers.
Step 1 Start the analyzers and the UWBTracer/Trainer software.
Step 2 From the menu, select Setup > All Connected Devices to open the
Analyzer Devices dialog box.
Figure 10.3 Analyzer Devices Dialog Box
Step 3 To select an analyzer, check the relevant Analyzer checkbox on the left.
Step 4 Click Close to close the dialog box and select the analyzer.
The UWBTracer/Trainer software on your screen now controls the
selected analyzer.