Teledyne LeCroy UWBTracer User Manual - Manual (Page 308)

Appendix A: MPI UWBTracer/Trainer User Manual
290
LeCroy Corporation
Table A.3 Adapter Pin Assignments: 40-Pin Probe Cable
A.2 Input Load of UWBTracer/Trainer MPI
Each MPI signal pin has a 220 ohm tapping resistor followed by a CMOS buffer with 10pF
of input capacitance. The resistor and buffer are within 2 inches of the connector on the
Cable Adapter or Board Adapter.
PHY MPI pin ------------------ Connector pin
|
|
|------ Resistor ------ Buffer
|
|
MAC MPI pin ------------------ Connector pin
Pin Definition Pin Definition
1 RESET 2 GND
3 DATA0 4 NC
5 DATA1 6 PWR
7 DATA2 8 PWR
9 DATA3 10 PWR
11 DATA4 12 PWR
13 DATA5 14 PWR
15 DATA6 16 PWR
17 DATA7 18 NC
19 GND 20 KEY
21 PCLK 22 GND
23 TX_EN 24 GND
25 RX_EN 26 GND
27 PHY_ACT 28 NC
29 DATA_EN 30 GND
31 CCA_ST 32 GND
33 SE_DAT 34 GND
35 STOP_C 36 GND
37 RSVD1 38 GND
39 RSVD2 40 GND