Teledyne LeCroy UWBTracer User Manual - Manual (Page 215)

UWBTracer/Trainer User Manual Chapter 12: Recording Options
LeCroy Corporation
197
To drag-and-drop the Event button:
Step 1 Place the mouse cursor on the Event button in the Available Events
area. Click the left mouse button.
Step 2 Drag the button to the cell. When the button is in the cell, a dashed
highlight line appears around the cell (Figure 12.13).
Figure 12.13 Drag-and-Drop Event Button to Cell
Step 3 Drop the button in the cell (release the left mouse button). The Event
button appears in the cell (Figure 12.14).
Figure 12.14 Event Button in Cell
As shown in Figure 12.14, the default label for the first cell is “Sequence 0, State 1." As
described later in this section, you can change that label using the Properties pop-up for
that cell.
As Figure 12.14 also shows, two new cells appear under the first cell. The first of these
new cells is a state cell that allows you to create another state in rule Sequence 0 (to
make Sequence 0 a multi-state sequence).
The second of the new cells is to create a separate sequence, which would be labelled
Sequence 1.