Teledyne LeCroy UWBTracer User Manual - Manual (Page 175)

UWBTracer/Trainer User Manual Chapter 10: Connecting to Analyzers
LeCroy Corporation
157
Chapter 10: Connecting to Analyzers
If you have one or more analyzers, you can link them directly to the host machine through
USB connections or through an IP LAN connection to a remote host machine.
If you have more than one analyzer, you must synchronize the analyzers. You must
synchronize local and remote analyzers using the SYNC IN and SYNC OUT cable
connectors and SYNC cables, as described in Section 10.3, “Multiple Analyzer
Synchronization” on page 162.
Note: UWBTracer/Trainer™ will not work with unsynchronized multiple analyzers.
10.1 Direct USB Connections
You can control multiple analyzers from a single UWBTracer/Trainer application by
connecting the analyzers to the PC using USB cables. UWBTracer/Trainer lets you toggle
among the analyzers.
Attach USB cables between each analyzer and the host PC as shown in Figure 10.1.
Figure 10.1 Connecting Multiple Analyzers by USB Cables
To synchronize recordings among the analyzers, connect SYNC cables to the analyzers’
SYNC IN and SYNC OUT connectors as described in Section 10.3, “Multiple Analyzer
Synchronization” on page 162.
After you have connected the analyzers and started them, you can add, remove, or
reconnect an analyzer using Setup > Analyzer Network ...
Note: You cannot run two copies of the UWBTracer/Trainer software on
simultaneously on a PC. You can only toggle among the analyzers using
Setup > Analyzer Network ...