2 remote access over an ip lan – Teledyne LeCroy UWBTracer User Manual User Manual
Page 177
UWBTracer/Trainer User Manual
Chapter 10: Connecting to Analyzers
LeCroy Corporation
159
Note: You can update the Firmware, BusEngine, and License from this dialog by
checking an analyzer and then clicking the appropriate button on the right.
You can also directly open and set Recording Options for any of the analyzers by
checking one or more analyzers and then clicking the Recording Options button
to open the Recording Options dialog. The settings you create apply to all
selected analyzers.
10.2 Remote Access over an IP LAN
You can run a UWBTracer/Trainer application on a remote PC from a second
UWBTracer/Trainer application on a local PC if both PCs are on a network. You must
install UWBTracer/Trainer on both host PCs and connect the PCs using an IP local area
network (LAN).
Attach a USB cable between each analyzer and its host PC, and connect the hosts PCs
on an IP LAN, as shown in Figure 10.4.
Figure 10.4 Connecting Multiple Analyzers by USB Cables on a Network
To synchronize recordings among the analyzers, connect SYNC cables to the analyzers’
SYNC IN and SYNC OUT connectors as described in Section 10.3, “Multiple Analyzer
Synchronization” on page 162.
After you have installed UWBTracer/Trainer on both PCs, connected the analyzers, and
started everything, you can toggle to the remote analyzer using Setup > Analyzer
Network ...
Note: You cannot run two copies of the UWBTracer/Trainer software on
simultaneously on a PC. You can only toggle among the analyzers using
Setup > Analyzer Network ...