Teledyne LeCroy UWBTracer User Manual - Manual (Page 238)

Chapter 12: Recording Options UWBTracer/Trainer User Manual
220
LeCroy Corporation
Using Independent Sequences
UWBTracer/Trainer supports up to two independent sequences. By default, they are
labeled Sequence 0 and Sequence 1.
The two sequences operate in parallel and have no effect on each other with the following
exception. Either of the two sequences can contain the action Restart All. This action
restarts both sequences in the Main Display area.
Example 6: Creating Independent Sequences
The following example adds a second sequence to Example 6. The second sequence
triggers recording if any MPI error is detected.
In this example, there are two conditions that trigger recording. The first condition is
defined by sequence 0. The second condition is defined by sequence 1.
Figure 12.45 Example 6: Two Independent Sequences