Teledyne LeCroy UWBTracer User Manual - Manual (Page 182)

Chapter 10: Connecting to Analyzers UWBTracer/Trainer User Manual
164
LeCroy Corporation
Recording Multi-Trace Files
After you connect SYNC cables to allow synchronization, perform the following steps to
record multiple trace files:
Step 1 Perform Steps 1 and 2 as described above in “USB Connected
Analyzers Configuration” on page 158 to open the Analyzer Devices
dialog box.
Step 2 In the Analyzer Devices dialog box, verify that the checkboxes are
checked for the cascaded analyzers.
Step 3 Click Close to close the dialog and select the analyzers.
Step 4 Test the setup by recording some traffic. If the analyzers are not
connected by SYNC cables, an error message prompts you to correct
the problem.
Step 5 The UWBTracer/Trainer software displays traffic from each analyzer in
adjacent windows.
10.4 Network Chat
Analyzer Network Chat is a utility that allows users to conduct chat sessions over an
IP LAN.
To send and receive electronic text messages, each user must be working with a PC that
is attached to an analyzer and each PC must, in turn, be connected to an IP LAN.
To start a chat session:
Step 1 Select View > Analyzer Network Chat Bar from the menu to open the
Analyzer Network Chat dialog:
Figure 10.10Analyzer Network Chat Dialog Box
Step 2 Click the cell at the bottom of the window and type any text.
Step 3 Click Send. The sent text appears in the top of the window next to your
prompt.