Teledyne LeCroy UWBTracer User Manual - Manual (Page 56)

Chapter 3: Software Overview UWBTracer/Trainer User Manual
38
LeCroy Corporation
3.16 Status Bar
The Status bar is located at the bottom of the Main window. Depending on the current
activity, the bar can be divided into as many as four segments (see Figure 3.20):
1. Notifications and Help (connection, disconnection, and other messages)
2. Progress Bar and Progress Report (see “Recording Progress” on page 40)
3. Status (of the MPI and RF channels)
4. Search Direction (Forward or Backward)
Figure 3.19 Status Bar Segments
The left-most segment shows a message that an Analyzer with serial number 1434 was
disconnected from the application
The status bar shows only the status of a single analyzer. If you place the cursor on the
status bar, a tooltip pops up (Figure 3.20) and displays the status of all the analyzers
connected to the application. In this example, three analyzers are connected to the
application.
To select a different device from the list in the tooltip and display its status in the status
bar, double-click Segment 3, the Status segment. The Status bar then displays
information about the next device displayed in the tooltip list. Double-click Segment 3
again to cycle through all the devices displayed in the tooltip list.