Teledyne LeCroy UWBTracer User Manual - Manual (Page 305)

UWBTracer/Trainer User Manual Appendix A: MPI
LeCroy Corporation
287
Appendix A: MPI
This appendix describes the pin assignments for the MPI Cables and connectors
supported in the LeCroy MPI Kit.
The tables in this appendix describe only the pins used for the MPI signals specified in
the WiMedia specifications. Other pins are marked as Reserved, Not Used, or
NA (Not Applicable).
Note: Pins marked as Reserved, Not Used, or NA (Not Applicable) may be used by
PHY and MAC vendors to implement additional propriety data and control protocols. The
following tables do not specify such proprietary signals. For more information about such
pins, refer to vendor documentation.
A.1 Cable Adapter Pin Assignments
Table A.1, Table A.2, and Table A.3 show connector pin assignments for the 68-pin,
60-pin, and 40-pin probe cables.
Section 11.2, “Connecting Cables and Adapters” on page 166 shows how the cables are
connected to the analyzer and adapter.