Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 54)

Teledyne LeCroy Patterns and Data Capture Setup
52 Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual
Figure 2.13: SAS: Choosing Capture Patterns
SAS vs. SATA: SATA Dialog replaces “Exclude SATA_CONT” with “Exclude CONT” and
“Exclude SATA_SYNC” with “Exclude SYNC”.
SAS: The SAS Parameters window displays the following pattern capture categories:
 STP Frame
 Address Frame
 SMP Frame
 SSP Frame
 Data Pattern
 Protocol Errors
SATA: The SATA Parameters window displays the following pattern capture categories:
 FIS
 FIS Pattern
 Data Pattern
 Protocol Errors
2.11.1 Choose a Parameter
To choose a parameter for capture from any of these categories, highlight the category in
the parameter window and click the Add>> button. This opens selection dialogs for each
of the categories displaying all of the parameters for that category. All patterns added
appear in the Project Tree.
2.11.2 Exclude Patterns
Check this box to allow for the capture of everything except the patterns that have been
added to the Project Tree.