Set timers – Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual User Manual
Page 104
Teledyne LeCroy
Advanced Mode (User‐Defined)
102
Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual
5. If you choose Pattern, you can select patterns for inclusion or exclusion. Clicking the
Pattern option enables a pattern definition dialog.
Figure 2.74: SAS: Choosing a Pattern
6. Choose pattern(s) and click the +>> button to add them for capture or exclusion. You
define each pattern the same way as in Easy mode (see
7. For an output trigger, click the down arrow in the Ext. Out field and choose an
output trigger level. Note: Do not use the LOW setting in Advanced Mode.
8. To go to another state, click the down arrow in the Go To field and select a state. If
no other state has been defined, choose New State to add a state.
Set Timers
You can set and use up to three timers for triggering. You can set each timer for each
state or continue from a timer set in the previous state. The timer defined for a particular
state starts when entering that state. To set timers, click the ellipses in the Timer field in
each state and define each of the timers in the Set Timers dialog.
Figure 2.75: Set Timers Dialog
Note:
Three timers are available. You have to set and start each timer in order to continue the next
timer. For example, you have to start Timer 1, continue it, then set Timer 2 in order to continue
it. It will not allow you to continue Timer 2 until you first set it.