Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 265)

Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual 263
Creating a Sequence Teledyne LeCroy
Figure 4.32: Example 6: Complete Scenario
9. In the File menu, select Save Scenario to save the scenario.
4.15 Creating a Sequence
This section gives several examples for creating sequences. Recall that a sequence can
have multiple states, but only one state is active at any time. In other words, at any point
in time, a sequence “waits” for one event (or combined event) and responds with the
corresponding action or set of actions when the event occurs.
A sequence is more powerful than Global Rules, because you can create branching or
looping test logic with a sequence.You can include up to two sequences in a scenario, but
each is completely independent of the other. There is no branching or other interaction
between the two, except through the Restart All Sequences action.
You must follow some simple rules when creating sequences:
TABLE 4.5: Sequence Rules
You can use only two branch actions per state.
When you specify actions for a state, you can only use two instances of Branch to an
Existing State or Branch to a New State. If you try to use more than two, a red error
message appears in the status area of the application that says “Too Many Actions.”
You can use only one restart sequence action per state.
When you specify actions for a state, you can only use one instance of Restart Current
Sequence or Restart All Sequences. If you try to use more than one, a red error message
appears in the status area of the application that says “Too Many Actions.”
You can use a maximum of 255 states per sequence.
If you try to use more than 255 states, a red error message appears in the status area of
the application.