Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 249)

Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual 247
Scenario Actions Teledyne LeCroy
TABLE 4.3: Test State Actions
Action Description
Beep Emits audible sound of duration. Select via drop‐down list.
Branch to
Existing State
1
Go to a state in this sequence that is already defined.
1
New State
1 Go to a state in this sequence that is not yet defined (you
need to define it).
1
Capture Data DWORD Captures a data DWORD into one of four registers.
Inject CRC Error Injects a CRC error into the line.
Invalid 10bit‐code
Error Injects invalid 10b code into the line.
Running Disparity
Error Injects a Running Disparity (RD) error into traffic.
Insert Address Frame
FIS Frame
SAS Primitive
SMP Frame
SSP Frame Inserts a frame or primitive.
Insert DWORD Inserts DWORD.
Link Disconnect Puts both InFusion SAS ports at electrical idle immediately.
This action is only in effect while the scenario is running,
and the Jammer will reconnect the line when the scenario
is stopped.
Reconnect Starts traffic pass‐through immediately. This action
restarts traffic after a previous disconnect command. Once
traffic is passing through, the initiator and target resume
OOB signaling.
Monitor/Count Opens a window to count the number of events that occur
during a session. A session is a time interval during which a
scenario runs.
Remove Frame Partially
Primitive
Whole Frame Removes the targeted event from the traffic.
Restart
All Sequences
1
Restart all sequences in the scenario.
1
Current Sequence
1
Restart the sequence that contains this action definition.
1
SNW Speed Negotiation
Retime Set RCDT, SNTT, ALT/TLT, TX speed, TRAIN/TRAIN_DONE
pattern, and/or PHY Capability.
Speed Negotiation
Violation Set Violation Type.
Stop Scenario Stops all scenario activity.
Substitute Data DWORD Substitutes a data DWORD in the traffic.
with SAS Primitive Substitutes a SAS primitive in the traffic.
with SATA Primitive Substitutes a SATA primitive in the traffic.