Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 45)

Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual 43
CrossSync Control Panel Teledyne LeCroy
The Analysis Project dialog offers you a comprehensive set of choices to create a trigger
and capture project satisfying some specific need. You can set the Analyzer to:
 Capture specific patterns (see "Patterns and Data Capture Setup" on page 51 ).
 Capture different patterns pre‐ and post‐trigger.
 Exclude parameters from capture.
 Trigger on a pattern or sequence of patterns (see "Trigger Setup" on page 66 ).
 Configure trace capture memory (Settings tab).
 Select file to save trace capture in memory (Settings tab).
 Include a project note (Notes tab).
2.6.1 Launch Jammer
The Launch Jammer option invokes InFusion. For more information refer to “InFusion
Overview” on page 227.
2.7 CrossSync Control Panel
The CrossSync Control Panel allows you to select analyzers for synchronization and
manage the recording process. It supports a wide combination of Teledyne LeCroy’s
flagship analyzers including PCI Express, USB, DDR, Serial ATA (SATA), Serial Attached SCSI
(SAS), Fibre Channel (FC) and Ethernet.
CrossSync is Teledyne LeCroy’s analyzer synchronization solution that enables time‐
aligned display of protocol traffic from multiple daisy‐chained analyzers showing packet
traffic from multiple high‐speed serial busses. A lightweight software control panel allows
users to select analyzers for synchronization and manage the recording process. Captured
traffic is displayed using the latest analyzer software (in separate windows) with all the
protocol specific search and reporting features.
Captured packets are displayed in separate windows that share a common time scale.
Navigating the traffic in either direction will scroll to the same timestamp in a
synchronized window. When using the CrossSync option, users can access the full
complement of analysis capabilities available within the individual Teledyne LeCroy
software. Search, reporting, and decoding all operate normally.
This feature is available with the Teledyne LeCroy SAS/SATA Protocol Suite application.
2.7.1 Launching the CrossSync Control Panel
To launch CrossSync from the SAS/SATA Protocol Suite software application, select the
‘Launch CrossSync Control Panel‘ entry in the ‘Project Setup’ menu (see
Figure 2.6 on
page 44 ) and (see Figure on page 44 ). Or, you can launch CrossSync from the ‘Start’
menu.