Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 128)

Teledyne LeCroy Analysis
126 Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual
.
Figure 3.23: Enabling Read/Write Statistical Report
Note: This settings should be enabled before you capture the trace file.
If you have already captured a trace file and want to create a read/write statistical report
for the sample, perform the following steps:
1. Enable the read/write settings as mentioned above.
2. Open the trace file.
3. Set the X pointer on the first packet in the viewer.
4. Set the Y pointer on last packet in the viewer.
5. Save as the trace file using the X to Y option.
Now the saved trace file will contain the read/write statistical report.
Report between Cursors
Click the option button next to the From cursor selection drop down list. Then click the
From down arrow and choose the 1st cursor, click the To down arrow to choose the 2nd
cursor, and click OK (see
Figure 3.24 on page 127 ). The resulting report has only the
capture between the cursors.