8 connecting via ethernet, 1 connecting to a network, 2 select device – Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual User Manual
Page 22
Teledyne LeCroy
Connecting via Ethernet
20
Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual
Note:
The Self Test, SAS Verification Test, SATA Compliance Test and Update License functions only
work on unit 1 when the analyzers are set up in cascading mode.
For Sierra M6‐1, M6‐2, and M6‐4 analyzers connected by Sync cables, the
SAS/SATA Protocol Suite application automatically synchronizes their recording
timestamps, starts, and stops.
For how to daisy‐chain two or more Sierra M6‐2 analyzers, see the Sierra M6‐2
User Manual. For how to daisy‐chain two or more Sierra M6‐4 analyzers, see the Sierra
M6‐4 User Manual.
Note:
You can use the Sync port to synchronize a Sierra M6‐1 analyzer to analyzers with different
protocols. You use a Micro‐D Sync cable (AC031XXA‐X) to connect to a Teledyne LeCroy Advisor
T3 analyzer. You use a Micro‐D to DB‐9 Sync cable (AC030XXA‐X) to connect to other Teledyne
LeCroy analyzers. For more information, see the CrossSync User Manual and/or see
.
1.8
Connecting via Ethernet
The Ethernet connection can have any of these configurations:
1. Analyzer connected to a network using a hub or switch, Gigabit Ethernet interface,
or similar device.
2. Analyzer connected to the host computer (machine running the application
software), using a hub or switch, Gigabit Ethernet interface, or similar device.
1.8.1
Connecting to a Network
When connected to a network, the analyzer can communicate with the DHCP server to
obtain IP address configuration information in order to establish a connection.
1.8.2
Select Device
After starting the software, click on Setup and select All Connected Devices (see the
following screen capture).