Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 173)

Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual 171
Navigation + View Toolbar Teledyne LeCroy
Use Pair SAS Addresses
You can use all available pair SAS addresses (Source ‐> Destination) instead of using SAS
source and destination addresses. To enable the pair SAS address filter option, check Use
Pair SAS Addresses check box in the Filter dialog.
Figure 3.89: SAS: SAS Address Filtering before and after Using Pair SAS Addresses
Note: If you enable pair SAS addresses, the source/destination SAS addresses options are disabled and
filtering on them is ignored at filtering time. If you disable pair SAS addresses, the pair SAS
address option is disabled and filtering on it is ignored at filtering time.
Training Sequence
When selected, depending on the Filter Type, the Hide/Show selection shows or hides
captured Training Sequences in the Trace Viewer.
3.5.5 Selectable Filter Options for SATA
The SATA filter options are:
 Bus Condition
 Incomplete Frames
 FIS
 ATA Command
 Protocol Error
 Port
 ATAPI SCSI Command
 Miscellaneous
 Filter Idle (see Figure 3.88 on page 170 )