Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 39)

Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual 37
Chapter 2
Protocol Analysis
A default analyzer project is created automatically when the application starts. An
analyzer project contains all the settings for capturing, triggering and memory usage. A
project can be saved as a *.sac files for later use.
2.1 Easy Mode (Pre-Defined Setups)
After you install the Analyzer software (see “Software Installation” on page 17 ) and set up
the Analyzer (see “Hardware Setup” on page 17 ), launch the Analyzer software (see
“Launching Your Analyzer” on page 25 ) to display the default Protocol Analyzer in Easy
Mode at the Capture tab.
The default Protocol Analyzer uses the Easy Mode which allows triggering and data
capture.
2.2 Main Window
Use Easy Mode to get a comprehensive overview of your analyzer’s capabilities. Use the
default Analyzer Project or create a new project.
For SAS: On the Analyzer Menu Bar, click File > New > SAS Protocol Analyzer to open a
SAS Protocol Analyzer dialog.