Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 267)

Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual 265
Example 7: Creating Two Sequences and Global Rules Teledyne LeCroy
3. Click the prompt to add a sequence. Prompts for the sequence appear beneath the
Global Rules area. You create a sequence one state at a time. The application
numbers states consecutively from 0 up (1, 2, 3, and so on).
Figure 4.33: Example 7: Adding a Sequence
By default, the name of the first sequence in a scenario is Sequence 0. The name of the
first state is State 0. To change the name of a sequence or state, or to associate a
description with it, click the name of the sequence or state. A dialog box appears that
allows you to enter that information.
Note: The description does not appear on screen, but you can bring it up by clicking the name of the
sequence or state.
4. In the State 0 area, click the prompt to add an event.
Figure 4.34: Example 7: Adding an Event for the First State
The Event Properties dialog box appears.
5. In the Event Properties dialog box, select Address Frame as the event.