3 project tree, 4 capture tab fields, Exclude sata_cont (sas) or exclude cont (sata) – Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual User Manual
Page 41: Exclude sata_sync (sas) or exclude sync (sata), Exclude oob signals, Exclude xxxx, Exclude align
Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual
39
Project Tree
Teledyne LeCroy
SAS vs. SATA: SATA Dialog does not show “Exclude RRDY” or “Exclude NOTIFY”.
SATA Dialog replaces “Exclude SATA_CONT” with “Exclude CONT” and
“Exclude SATA_SYNC” with “Exclude SYNC”.
2.3 Project
Tree
The Project Tree on the right side of the main window displays a comprehensive tree
structured overview of the project. The project tree shows the capture configuration,
trigger setups, and the capture memory settings.
2.4
Capture Tab Fields
The Capture tab has the following fields:
Exclude SATA_CONT (SAS) or Exclude CONT (SATA)
Check this to exclude SATA_CONT primitives from the data capture.
Exclude SATA_SYNC (SAS) or Exclude SYNC (SATA)
Check this to exclude SATA_SYNC primitives from the data capture.
Exclude OOB Signals
Check this to exclude OOB signals from the data capture.
Exclude XXXX
Check this to exclude XXXX patterns from the data capture.
Note:
The validity of time stamps during Idles is traded off against good buffer memory utilization
when using ‘Exclude XXXX’.
Exclude Dev Slp Packets (SATA)
Check this to exclude Dev Slp Packets from the data capture.
Exclude Payload except
Check this to exclude Payload of Data Frames from the data capture. You can except a
number of DWORD(s).
Note:
) does not reflect excluded Payload of Data
Frames.
Note:
When showing truncated data in the Data Payload View, the truncation points are marked with
a separator placed between payloads. You can get more information about the data exclusion
using the tooltip over the separator.
Exclude ALIGN
Check this to exclude ALIGN primitives from the data capture.